A Little Backpack

Hi!  Today I am sharing the little treat bags I made for On Stage friends.  I had so much fun putting them together!

3D,, Backpacks, Gift Bag Punch Board, Stampin' Up!, SU!,

These little bags are made using the Gift Bag Punch board – a medium sized bag.  A little front pocket was made using the Delightful Daisy Designer Series Paper.  The top flaps are a separate piece from the bag.  I didn’t snag a picture of the back, but there  are two ribbons that act as straps  for back of the little backpack.

Here is what was inside these little bags:

Backpacks, Gift Bag Punch Board, Stampin' Up!, SU!

A few little treats, post-it flags, and a mini pen.  I think everyone liked them!

Here are the dimensions for the bag:

6″ x 11″ piece of Cardstock – use the Gift Bag Punch board to make a medium bag. (Do not assemble yet)

Use the 1/8″ hole punch to punch two holes on the back of the bag above the bottom flap.

Cut two pieces of  ribbon 7″ long and knot one end.  Run these through the holes so the knot will be on the inside of the bag.

Assemble the box.

For the top flap, cut a piece of cardstock 3 1/8″ x 2 1/2″.  Score at 1 1/2″ on the 2 1/2″ side.

Punch two holes on the score line 1″ in from each end.  Use a 3″ piece of ribbon through these two holes to create the handle on the top.  Adhere ends down with Tear & Tape to the smaller section created by  the score line.

Use the gift bag punch board to just punch the two ends of the cardstock to create the flap.

Stamp your sentiment on the flap

Punch a hole in the middle of the 1″ side created by the score line for the two ribbons to fit through.

Adhere these two ends down using Tear & Tape.

Attach this 1″ section to the back of the bag to adhere the flap.

For the front pocket, cut a piece of Designer Series Paper  4″ x 2 3/4″.  Score the 4″ side at 1/4″, 1/2″, 3/4″ 3 1/4″, 3 1/2″ and 3 3/4″.  Score the 2 3/4″ side at 1/4″ , 1/2″ and 3/4″.  Cut off the two corners where the score lines intersect.  Fold score lines mountain, valley, mountain and use Mono Multi Glue to attach the three sides to the front of the bag.

For the flap, cut a piece of cardstock at 2 1/2″ x 1 1/4″. Score the 1 1/4″ at 3/4″.   Round the corners on the front and use Tear & Tape to attach the little flap to the front of the bag with the fold over the little pocket.

Use small pieces of Velcro to hold the two flaps down.

Don’t forget, the retirement list is out!  Items are starting to sell out – so don’t delay in getting those orders in – I’d hate for you to not get what you want!

Shop my on-line store at:  Teresa’s Stampin’ Spot

Use hostess code: WZ627AK3 

Thanks for stopping by!

Product List

Leave a Reply

Your email address will not be published. Required fields are marked *